Loading ...
Loading ...
Loading ...
for 2 seconds. When Leds light on, press buttons:
(within 5 seconds). Leds ashing 6 times indicate
the procedure is completed.
WARNING! This operation deletes permanen-
tly the preset codes.
Emergency button:
In the event that the radio control does not work,
use the emergency button to switch the appliance
off. After any necessary repairs have been perfor-
med, reset the emergency button.
WARNING
The battery should be replaced every year to
guarantee the optimal range of the transmitter.
To replace the exhausted battery, take the pla-
stic lid off, remove the battery and replace it
with a new one, observing the correct battery
polarities.
Used batteries should be discarded in special
collection bins.
The below product:
RC001 Radiio Controll
complies with the specications set out in the
R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modications which have
not been expressly approved by the holder of
the legal conformity certicate may invalidate
the user’s rights relating to the operation of
the device.
Rev.026/08/14
9
The products are endowed with an electronic de-
vice which allows the automatic switching off after
4 hours working from the last operation.
An accurate maintenance guarantees good fun-
ctioning and long-lasting performance. Special
care needs to be taken with the grease lter:
to access the lter, proceed as described in the
PANEL OPENING chapter.
Remove the grease lter, using the special handle.
To ret the grease lter after cleaning, carry out
the same operation in reverse order.
To remove the carbon lter, if tted, follow the
same steps as for the grease lter.
The carbon lter is located immediately above
the grease lter.
Tepid water and neutral detergents are recom-
mended to clean the appliance, while abrasive
products should be avoided.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualied person in order to avoid a hazard.
MAINTENANCE
Loading ...
Loading ...
Loading ...