Loading ...
Loading ...
Loading ...
EN
W415-1352 / A / 03.06.15
15
6.0 MAINTENANCE
6.1 PCB (CONTROL BOARD)
!
WARNING
PREPARATION FOR MAINTENANCE
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
To replace the PCB remove the glass door see "GLASS DOOR REMOVAL" section.
A. Remove the crystal media from the appliance.
B. Remove the plastic panel prior to accessing the circuit board.
C. Remove the 4 screws and replace the existing PCB with the new PCB.
6.2 REMOTE BATTERY INSTALLATION
1. Turn over the remote with rear side facing up. Slide
the battery cover off the remote.
2. Place type CR 2032 battery into the remote and
reinstall the battery cover by sliding it into position,
as shown. NOTE: For ease of installation, hold
the battery while sliding the cover onto the
remote
3. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
REMOTE
(REAR SIDE)
BATTERY (CR 2032)
BATTERY COVER
Loading ...
Loading ...
Loading ...