Loading ...
Loading ...
Loading ...
Feed the wOrkpiece by hand along the AUXLIARY
FENCE/WORK SUPPORT Until the end is approx. 1 in.
past the front edge Of the table. Continue to feed using the
PUSH BLOCK.
Hold the workpiece in position and install the PUSH
BLOCK by Sliding it on top of the AUXILIARY
FENCE!WORK SUPPORT (this may raise guard).
BAFFLE
Narrow strips thicker than the Auxiliary Fence/Work Support
may enter the guard and strike the baffle. CAREFULLY raise
guard only enough to clear the workpiece. Use PUSH BLOCK
to complete cut,
RESAWING
RESAWING is known as ripping a piece of wood through
its thickness. Do not attempt to resaw BOWED or
WARPED material NOTE: to RESAW a piece of wood
wider than 2-1/2 in.... it will be necessary to remove the
blade guard ... and use the AUXILIARY FENCE/WORK
SUPPORT (See Page 18)
Clamp it to the table so that the workpiece will SLIDE
EASILY (but not TILT or MOVE SIDEWAYS) without
BINDI NG between the two fences.
Do not clamp directly to the bottom edge of the table
because the "swivel" of the clamps wilt not grip properly.
Place a small block of wood between the bottom edge of
the table and the "C'" clamps,
WARNING: FOR YOUR OWN SAFETY...
1 DO NOT "BACK UP" (REVERSE FEEDING) WHILE
RESAWING BECAUSE THIS COULD CAUSE A
KICKBACK.
SMALL BLOCK
OF WOOD
/
2. INSTALL BLADE GUARD IMMEDIATELY UPON
COMPLETION OF THE RESAWING OPERATION.
CUTTING PANELS
When cutting panels (whenever fence is positioned outside
of table surface), ALWAYS use the AUXILIARY
F ENCE/WOR K SUPPORT.
1, Unlock fence and raise rear end.
2. Position AUXILIARY FENCE_VORK SUPPORT as
shown and attach it with two "'C" clamps.
22
_,UXlLIMY FENCE/"
WORK SUPPORT
/
Loading ...
Loading ...
Loading ...