Loading ...
Loading ...
Loading ...
2 RESET BUTTON .. See "Motor Specifications and
Electrica Requirements" section. "Motor Safety
Protection."
NOTE: When bevel crosscutting, attach facing so that it
extends to the right of the miter gauge and use the miter
gauge in the groove to the right of the blade.
3 ELEVATION HANDWHEEL... elevates or lowers the
blade. Turn clockwise to elevate.., counterclockwise
to lower.
NOTE: WHEN THE BLADE IS TILTED TO 45 ° , IT
CANNOT BE LOWERED ALL THE WAY BELOW
THE TABLE. IT WILL PROJECT APPROX. 1/2 IN
4 TILT HANDWHEEL ... tilts the blade for bevel
cutting. Turn clockwise to tilt toward left ...
counterclockwise to tilt toward right.
When the blade istilted to the LEFT asfar as it will go,
it should be at 45° to the table and the bevel pointer
should point 45°.
NOTE: There are LIMIT STOPS inside the saw which
prevent the blade from tilting beyond 45° to the LEFT
and g0° to the RIGHT. (See "Adjustments" section
"Blade Tilt. or Squareness of Blade to Table").
7
5
RIP FENCE ... is locked in place by tightening the
lock knob. To move the fence, oose_ the lock knob
and graspthe fence with one hand at the front.
8
Holes are provided in the rip fence for attaching awood
facing when using the dado head, or molding head.
\
\
\
\
BLADEGUARD must always he in place and working
properly for all thru-sawing cuts. That is, all cuts
whereby the blade cuts completely through the
workpiece.
To remove the guard for special operations, loosen the
wmgscrews and move spreader awm/ from saw and lift
upwards. DO NOT DISTURB THE SETTING OF THE
REX NUTS.
When replacing the guard, make sure the spreader is
moved toward front of saw so that wingscrews are at
end of slots. TIGHTEN THE WlNGSCREW_S
SECURELY.
TABLE INSERT is removable for removing or installing
blades or other cutting tools..
Select a piece of smooth straight wood appro×, 3/4 in,
thick and the same size as the rip fence.
Attach it to the fence with three Round Head # f0
Wood Screws 2 in, long. To remove the facing, loosen
the screws, slide the facing forward and pull the screws
throu_ the round holes.
ANTIKICK BACK
PAWLS
WOOD FACING
\
#1oWOOD SCREWS
6 MITER GAUGE .. head is locked in position for
crosscutting or mitering by tighting the lock knob,
ALWAYS LOCK IT SECURELY WHEN IN USE.
Notches are provided in the miter gauge for attaching
an AUXILIARY FACING to make it easier to cut long
pieces, Be positive facing does not interfere with the
proper operation of the sawblade guard.
Select a suitable piece of smooth straight wood.., drill
two holes through it and attach it with screws.
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE REMOVING INSERT.
A, Lower the blade below the table surface.
B. Loosen screw.
C. Lift antikickback pawls.
D. Lift insert from front end, and pull toward front of
saw.
NEVER OPERATE THE SAW WITHOUT THE PROPER
INSERT IN PLACE. USE THE SAW BLADE INSERT
WHEN SAWING .,. USE THE COMBINATION DADO
MOLDING INSERT WHEN DADOING OR MOLDING.
\
16
Loading ...
Loading ...
Loading ...