Loading ...
Loading ...
Loading ...
28
28
CONVERSION TO ULPG
The gas oven has been configured to operate on natural gas only. To
operate on ULPG the oven must be converted. The conversion kit is
provided with your oven.
This is a relatively simple task but must be undertaken by a licensed gas
fitter.
No responsibility will be accepted by Glem Gas if this requirement is not
met and it will void the warranty
To Convert to ULPG Operation –
Disconnect the electricity and gas.
1. Remove all oven shelves and grill tray.
2. Remove the cover plate in the base of the oven.
3. Undo the burner mounting screw. There is one mounting screw at the
front of the burner.
4. Move the burner assembly slightly forward and to the side to expose
the injector. Be very careful not to damage the thermocouple or
ignitor lead.
5. Using a 7mm socket remove the injector.
6. Using the same socket, screw in the supplied injector, after first
checking the size against the data plate.
If there is any doubt
please contact Glem Gas service on 02 9721 2755.
7. Carefully reassemble the oven burner.
8. Switch on the oven and check the size of the flame. It should be a
steady blue flame that is not too big to protrude beyond the burner
plate. Run the oven for a period of time at 180C until it reaches
temperature. This is to check that once the oven reaches
temperature the flame remains alight when it reduces.
9. Adjust as required. (see below)
10. Reinstall the cover plate.
11. Reinstall the oven shelves and grill tray.
12. Change the gas specification on the data plate and affix the ULPG
label to the rear of the oven exterior.
Loading ...
Loading ...
Loading ...