Loading ...
Loading ...
Loading ...
22
4. After installation, check to insure that gas valve orifices are correctly placed inside ends of
burner tubes. Also check position of spark electrode.
Sear Burners: Sear burners are made out of ceramic and emit gas in a honeycomb pattern that is
almost impossible to see. However, these burners get exceptionally hot and can be exceptionally
easy to damage. The way to clean these burners is:
1. Remove all large pieces of food from the top of the burner
2. Turn the burner on high and let the temperature do the work
3. Do not leave the grill unattended while doing this as you will want to make sure no excessive
flare ups occur
4. Once all excess grease has been burned off, you are ready to go!
a. An easy way to keep your sear burner from getting dirty is to allow it to run for a few
minutes after you are done cooking, so that you do not have to re-heat your grill just
to clean.
STAINLESS STEEL
After initial usage, areas of the grill may discolor from the intense heat given off by the burners. This is
normal. Purchase a mild stainless steel cleaner and rub in the direction of the grain of the metal. Specks
of grease can gather on the surface of the stainless steel and bake on to the surface and give a worn
appearance. For removal, use a non-abrasive oven cleaner in conjunction with a stainless cleaner. If
spots are persistent, then petroleum jelly may be used to help remove the spots.
NOTE:
Always scrub in the direction of the grain.
HOW TO CHANGE THE LIGHT BULBS
- (50” Hybrid)
1. Remove the screw holding the bulb lens.
2. Reach in using your fingers only, grip the two outside edges of the light bulb, do not grip the top
or bottom of the bulb, as it might break. Pull the bulb straight out, so that the two electrode wires
are completely removed with bulb. Place bulb in trash.
3. When installing the new halogen bulb be sure to use a clean cloth or paper towel to ensure the
longevity of the bulb.
4. Insert the new bulb using your clean cloth and gently snap it into position. Wipe off any
fingerprints and/or grease that may have transferred to the bulb.
5. Re-install the bulb lens and cover
6. Flip the switch on to check lights.
ANNUAL CLEANING OF GRILL HOUSING
Burn-off the barbecue after every cookout will keep it ready for instant use, however, once a year you
should give the entire grill a thorough cleaning to keep it in top operating condition.
1. Shut off gas supply at source and disconnects fuel line. Protect fuel line fitting.
2. Remove and clean the cooking grids, flavorizers and burners.
3. Remove warming rack and wash with mild detergent and warm water.
4. Cover the gas valve orifices with a piece of aluminum foil.
5. Brush the inside and bottom of the grill with a stiff wire brush, and wash down with a mild soap and
warm water solution. Wash thoroughly and let dry.
Loading ...
Loading ...
Loading ...