Loading ...
Loading ...
Loading ...
INITIAL INSTALLATION
7
DOWNROD-STYLE FAN MOUNTING
4
Open End
B
B
E
Secure mounting bracket (B) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket
(B) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (B) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19°.
4.
5.
Remove motor screw/washers (Q) from
underside of motor housing (E) and save for
blade arm attachment later on. [If there are
plastic motor blocks installed with the motor
screws/washers (Q), discard the plastic motor
blocks.]
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 9.
Remove pin (O) and clip (P) from downrod (A).
Partially loosen preassembled set screws and
nuts in yoke at top of motor housing (E).
1a.
1b.
1a
P
E
O
1b
A
Yoke
Set Screw
& Nut
Sideview
ANGLE
MOUNT
STANDARD
MOUNT
Plastic
Motor
Block
Q
5
Plastic Motor Block
Loading ...
Loading ...
Loading ...