Loading ...
Loading ...
Loading ...
Problem
Possible Causes
What to Do
Washer is unplugged
Water supply is turned off
Controls are not set properly
Lid is open
Circuit breaker/fuse is
tripped/blown
0
0
* Close lid and pull Cycle knob out to ON
position.
@
Make sure cord is plugged securely into a
working outlet.
Turn both hot and cold taps fully on.
Check controls and make sure Cycle knob
is pulled out to ON position.
Check house circuit breakers/fllses. Replace
fuses or reset breaker. Washer should have
separate outlet.
Control is not set properly
Water supply is turned off
or improperly connected
Water valve screens are
stopped up
House water heater is not set
properly
Check water temperature control and adjust.
Turn both hot and cold taps fully on and
make sure hoses are connected to correct
taps.
Turn off the water source and remove the
water connection hoses from the upper back
of the washer. Use a brush or toothpick to
clean the screens in the machine. Reconnect
the hoses and turn the water source back on.
Make sure house water heater is delkering
water at 48°C.-65°C. (120°F.-150°F.).
Drain hose is kinked or
improperly connected
• Straighten drain hose and make sure
washer is not sitting on it.
• Top of drain outlet should be less than
lm (3 ft.) above floor.
11
Loading ...
Loading ...
Loading ...