Loading ...
Loading ...
Loading ...
16 www.dimplex.com
glass.
12. Replace log grate, using two screws previously re-
moved.
13. Mount the wall controller within a standard electrical
device box, located within 50ft (15m) of the rebox and
install cover plate. (See included instructions for elec-
trical installation and requirements.)
14. Initialize the remote control to the new receiver installed
in the replace as per the instructions included in the
remote packaging.
BF PLUG KIT REPLACEMENT
(BFPLUGE)
!
NOTE: This accessory is only for 110/120V use only.
Tools Required: Philips head screwdriver
WARNING: If the replace was operating prior to
servicing allow at least 10 minutes for light bulbs and
heating elements to cool off to avoid accidental burning
of skin.
WARNING: Disconnect circuit power before attempt-
ing any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
1. Unplug the replace from the wall outlet.
2. Locate the voltage selector switch on the top corner
of the replace and make sure the switch is set to 115
V. (The switch should already be set to 115V from the
original installation of this optional accessory cord.
Power cord/Plugs are only approved for operation on
the BF33, BF39 or BF45 in 110 – 120 volt application.
Fireplace must be removable from the wall for access
when a plug kit is being used).
3. Loosen the screw securing the junction box cover on
the lower right hand side panel toward the back and
remove the cover.
4. Pull out the four wires marked L1, L2, N, and G.
5. Replace the black L1 wire from the unit to the non-
ribbed L1 wire from the power cord, connect the red L2
and white N wires from the unit to the ribbed or neutral
from the power cord. (Wide blade on the plug is the
neutral side of the power cord), connect a wire connec-
tor to the green ground wire from the unit.
6. Ensure that all wire connections are tight.
7. Re-Install the junction box cover and tighten the screw.
8. Plug the replace back into the outlet for power.
9. If replace has a BFRC-KIT (remote control kit) used
to operate the unit, the remote control may need to be
re-synchronized to the replace once power has been
restored to the replace.
Loading ...
Loading ...
Loading ...