Loading ...
Loading ...
Loading ...
www.usaprocom.com
200068-01A18
INSTALLATION
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation
and periodically thereafter,
check to ensure that no yellow
ame comes in contact with any
log. With the heater set to High,
check to see if yellow ames
contact any log. If so, reposi-
tion logs according to the log
installation instructions in this
manual. Yellow ames contact-
ing logs will create soot.
Figure 26 - Installing Logs #1, #2, #3 and #4
(WZL30MVA Shown)
Figure 25 - Log Base (WZL30MVA Shown)
It is very important to install the logs exactly
as instructed. Do not modify logs. Use only
logs supplied with heater.
Each log is marked with a number. This
number will help you to identify the logs when
installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
1. Insert pins on the back of log #1 into the
slots on the rear log bracket on the back
of the grate base (see Figure 26).
2. Insert pins on the back of log #2 into the
slots on the left side of the middle log
bracket (see Figure 26).
3.
Insert pins on the back of log #3 into the
slots on the right side of the middle log
bracket (see Figure 26).
4.
Insert pins on the back of log #4 into
the slots on the left side of the front log
bracket (see Figure 26).
Log #1
Log #2
Log #3
Rear Log Bracket
Middle Log Bracket
Front Log Bracket
Log #4
Loading ...
Loading ...
Loading ...