Loading ...
Loading ...
Loading ...
www.usaprocom.com
200068-01A12
INSTALLATION
Figure 11 - Attaching Heater Base to
Fireplace Floor
Masonry Screw
Mounting Bracket
2. Mark screw locations through holes in
mounting brackets (see Figure 11). If
installing in a brick-bottom replace, mark
screw locations in mortar joint of bricks.
3. Remove heater base from replace.
4. Drill holes at marked locations using 3/16"
drill bit.
5. Apply pipe joint sealant lightly to tting
threads. Connect approved exible gas
hose to gas regulator of heater (see Fig-
ure 11). Note: Never apply pipe sealant
to are tting threads. Hold gas regulator
with a wrench when connecting exible
gas hose.
6. Attach base assembly to replace oor
using two masonry screws provided in
hardware package (see Figure 11).
7. Connect to gas supply. See Connecting
To Gas Supply, page 13.
WARNING: You must secure
this heater to replace oor. If
not, heater will move when you
adjust controls. Moving heater
may cause a gas leak.
WARNING: If installing in a
sunken replace, special care
is needed. You must raise the
replace oor to allow access to
heater control panel. This will in-
sure adequate air ow and guard
against sooting and controls
being damaged. Raise replace
oor with noncombustible mate-
rial. Make sure material is secure.
CAUTION: Do not pick up
heater base assembly by burners.
This could damage heater. Only
handle base assembly by grates.
IMPORTANT: Make sure the heater burners
are level. If heater is not level, heater will not
work properly.
Installation Items Needed
• hardware package (provided with heater)
• electric drill with 3/16" masonry drill bit
1. Position heater base assembly in re-
place. Center base assembly left to right
and front to back inside replace.
INSTALLING HEATER BASE ASSEMBLY
Loading ...
Loading ...
Loading ...