Loading ...
Loading ...
Loading ...
28
Health and Safety
Consumer Protection
As responsible manufacturers we take care to make sure
that our products are designed and constructed to meet the
required safety standards when properly installed and used.
IMPORTANT: Please read the accompanying
warranty.
Any alteration that is not approved by AGA could invalidate
the approval of the appliance, operation of the warranty and
could also aect your statutory rights.
In the interests of safety and eective use, please read the
following before using your new AGA appliance.
Installation Requirements
THIS APPLIANCE MUST ONLY BE INSTALLED BY PERSONS
THAT ARE CERTIFIED TO LOCAL REGULATIONS.
NOTE: This installation instruction should be left with the
appliance and the owner to retain for future use.
Before installation of an AGA can be made, the site is
inspected for suitability by an authorized AGA distributor and
corrected where necessary to conform with local or regional
electrical codes.
USA
Model Number AGA TC3
FCC ID: A2M-AGA-TC3
FCC ID: A2M-AGA-TC3TEK
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CANADA
Model Number AGA TC3
IC: 10181A-AGATC3TEK
Model Number AE4M280526
IC: 10181A-AGATC3
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
11. Installation Introduction
In your own interest and that of safety to comply with the
law, all appliances should be installed by an authorized AGA
distributor in accordance with the relevant regulations.
Delivery Requirements
• The AGA TC3 arrives on 1 pallet
There must be access to the kitchen to manipulate a foot
print of 39 ⁄” (1005mm) x 29 ⁄” (740mm). A wooden
template (skate with castor wheels) of dimensions 39 ⁄”
(1005mm) x 29 ⁄” 740mm could be used to check if the AGA
Total Control fully built appliance is able to t through the
property grounds and doors into its installation position in
the kitchen. It must also be considered that the height of the
appliance is 37 ⁄” (960mm) o pallet and 43 ⁄” (1100mm)
on the pallet, so high level obstacles/restrictions must not be
overlooked.
If this skate/template can be manipulated through the
property grounds and doors into position, then the AGA
can be installed as intended with no re-work.
Loading ...
Loading ...
Loading ...