Loading ...
Loading ...
Loading ...
9
PLEASE NOTE:
• Don’t forget to include time for warm-up.
• Don’t forget if you have set the AUTO program and have
selected the AUTO mode, an oven or ovens must be
selected.
• The hotplates can only be operated manually.
• The last ‘AUTO’ oven selection is remembered and re-
called when ‘AUTO’ is next selected.
DO NOT OPERATE WITH THE APPLIANCE DOORS
OPEN
AUTO/Slumber (ovens only) - brings selected ovens up to full
heat from Slumber.
The ovens can be selected to operate once or twice each day.
Each operation is termed an ‘event’, the start and nish time is
chosen by you unless you use the pre-set time.
See page 12 to set your own Auto program preferences.
1. Select ‘AUTO/Slumber’.
2. Select oven (s) for automatic operation, by pressing the
appropriate buttons.
3. The oven (s) selected is indicated by an orange light
(unless you have selected ‘AUTO/Slumber’ during an
‘event’ period). During an ‘event’ period the light will be
green.
4. The oven (s) selected is indicated by an orange light, the
oven light will ash orange until ‘Slumber’ temperature
has been reached.
5. The oven light will ash green while the oven is heating
from ‘Slumber’ to full temperature during its Auto/
Slumber event period. When at full temperature the
green light will stop ashing.
PLEASE NOTE:-
• Don’t forget to include time for warm-up.
• Don’t forget if you have set the AUTO/Slumber program
and have selected the AUTO/Slumber mode, an oven or
ovens must be selected.
• The hotplates can only be operated manually.
• All the selected ovens will remain at ‘Slumber’ between
‘events’.
• The last ‘AUTO/Slumber’ oven selection is remembered
and re-called when ‘AUTO’ is next selected.
DO NOT OPERATE WITH THE APPLIANCE DOORS
OPEN
AUTO and AUTO/Slumber
Changing between any of the four operating modes, will
cause the hotplates to switch OFF if in use - this is a built-in
safety factor. They can be switched back on after the mode
change if required.
General Advice
Food SHOULD NOT be placed into any oven until it is up
to normal operating heat i.e. the green light of the selected
oven is solid and not ashing.
The oven doors should not be left open for long periods of
time during cooking and heating up.
Store the cold plain shelf outside the cooker. Use it cold in
the roasting oven to deect heat from the top of the oven,
creating a more moderate oven temperature underneath. It
can also be used as a baking sheet.
When an oven or hotplate is at temperature, and is then
loaded with food or cold pans/trays, the zone light may ash
as the oven and/or hotplate calls for extra heat.
Warm up times
When a zone is heating up it will be indicated by a ashing
green or orange light on the control panel. When a zone
has reached temperature a solid green or orange light will
indicate it has warmed up, AGA recommends that for full heat
to saturate the castings it is best to leave them for one hour
for the optimum cooking results.
Boiling Plate
The boiling plate takes approximately 11 minutes to reach
temperature from cold.
Simmering Plate
The simmering plate takes approximately 8 minutes to reach
temperature from cold.
Roasting Oven
The roasting oven takes approximately 35 minutes to reach
temperature from cold, and approximately 15 minutes to
reach temperature from ‘Slumber’.
Baking Oven
The baking oven takes approximately 22 minutes to reach
temperature from cold, and approximately 15 minutes to
reach temperature from ‘Slumber’.
Slow Cook Oven
The slow cook oven takes approximately 45 minutes to reach
temperature from cold.
PLEASE NOTE: For optimum cooking performance, after
the temperature has been reached, we recommend leaving
for another 30 minutes for the castings to become heat
saturated, particularly relevant if you are cooking a large meal
or baking.
PLEASE NOTE: The times are based on each zone being
operated individually. If a large combination of zones are
turned on simultaneously, it may slow down the individual
warm up times. If all zones are turned on at the same time it
will take approximately one hour for the whole appliance to
reach operating temperature.
These times are based on the cooker having a single
phase supply of 36 amps @ 240 V. For other power supply
congurations, these times may change.
Loading ...
Loading ...
Loading ...