Loading ...
Loading ...
Loading ...
PROBLEM SOLUTION
4.Thewalkingbeltis
off-centerorslips
whenwalkedon
Ifthewalkingbelthasshiftedtothe
left,firstremove the key and UNPLUG
THE POWER CORD. Using the allen
wrench, turn the left rear miler adjustment
holt clockwise, and the dghtholt counter-
clockwise, 1/4 of a turn each. Be careful
not to overUghten the walking bell Plug In
the power cord, insert the key and runthe
treadmill for a few minutes. Repeat until the walking belt Is centered.
b. If the walking belt has shifted to the right, b
first remove the key and UNPLUG THE
POWER CORD. Using the allen wrench,
rum the left rear roller adjustment holt
ocunterclockwise, and the dght boll clock-
wise, 114 of a tum each. Be careful not to
overtighten the walking belt. Plug in the
power cord, insert the key and runthe
treadmill for a few minutes. Repeat until the walking bell is cantered.
C, !f the walking bell slips when walked on,
first remove the key and UNPLUG THE
POWER CORD. Using the allen wrench,
tum both rear roller adjustment bolts clock-
wise, 1/4 of a turn. When the walking belt
is correctly tightened, you should be able
to lift the edgea of the walking bell 3 to 4
inches off the walking platform. Be careful
to keep the walking belt cantered. Plug in the power cord, insert the key and run
the treadmill for a few minutes. Repeat until the walking bell Is properly tightened.
5. An error code ('El,"
=E2," "E3," or "E4,")
appears In the SPEED
display
a.
If error code "El," "E2," or "E3" appears in the SPEED display, remove the key,
wait for ten seconds, and then reinsert it. If the error code appears again, call our
Customer Service Department. Do not operate the treadmill until the problem
is corrected.
b,
Error code "E4" may appear inthe SPEED display ifthe walking belt is moving at
a slow speed and there Is excessive stress on the motor. If this occurs, remove
the key, wait for ten seconds, and then reinsert it. If you weight over 200 pounds,
it may also be helpful to increase the Incline of the treadmill. Ifthe error code al_-
pears again, call our Customer Service Department. Do not operate the treadmill
until the problem is corrected.
6. The walking belt - -a. Use a color-fast upholstery cleaner to clean the walking belt. Test the
becomes soiled cleaner on a small area before cleaning the entire belt.
7. Bubbles form in the a. Due to variations in humidity and temperature, there is a possibilitythat
walking belt bubbles may form in the walking belt. Although the bubbles will disappear with
time, you may unplug the power cord, carefully insert a needle intothe bubbles,
and push the air out of the bubbiss.
18
Loading ...
Loading ...
Loading ...