Loading ...
Loading ...
Loading ...
Supervisor level
101
Running a RemoteUpdate
If a RemoteUpdate is available for your
tumble dryer, it will be displayed
automatically when the supervisor level
is open.
You can choose to start the
RemoteUpdate immediately or wait until
later. If you select “Start later”, the
prompt to run the RemoteUpdate will
be displayed again the next time you
switch on your tumble dryer.
The RemoteUpdate can take a few
minutes.
Please note the following information
about the RemoteUpdate function:
– You will only receive a message when
a RemoteUpdate is available.
– Once a RemoteUpdate has been
installed, it cannot be undone.
– Do not switch off the tumble dryer
during a RemoteUpdate. Otherwise,
the RemoteUpdate will be aborted
and will not be installed.
SmartGrid
The SmartGridsetting is only visible if a
WiFi network has been set up and
activated. This function can be used
for starting your tumble dryer
automatically at a time when your
energy supplier's energy costs are
most economical.
Activating SmartGrid gives the timer
sensor a new function. Use the “Timer”
sensor control to configure SmartStart.
The tumble dryer will then start within
the timeframe specified when it receives
a signal from the energy supplier. If it
has not received a signal from the
energy supplier by the latest start time
set, the tumble dryer will start
automatically.
Factory default: Off
Loading ...
Loading ...
Loading ...