Loading ...
Loading ...
Loading ...
C
28
Installation
I
nstallation
How to install the drain hose
1. Fit the machine end of the drain hose to the outlet of the drain
pump and tighten the clamp.
2. Put the other end of the drain hose over the standpipe or wash tub.
3. Fit the plastic holder into the holes located at either side of
the rear of the machine. The holder will fit in either
direction according to location of the standpipe.
4. Make sure that the holders the drain hose firmly so that the
drain hose does not hang down as shown in the fig.
Flooding drainage
• Your machine requires a floor drainage slope Or hole that will SAFELY DISPOSE of the FULL FLOW of
any water that may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a
drain hole (or slope)that will prevent any possibility of water damage to floor coverings or property.
Connect the inlet hose
• Check that sealing washers are firmly seated.
• Attach the curved end of the hose to the inlet valve of the washing
machine; Tighten the coupling nuts securely by hand.(Fig.1)
• Attach the straight end of the hose to the tap.
Tighten the coupling nuts securely by hand.(Fig.2)
• Either hose can be attached to the hot inlet valve and tap.
• Turn on the taps and check for leaks. Do not use any tools or over
tighten. Hoses should be hand tightened only. A soft cloth can be
used to help tighten if necessary. Tighten the coupling nuts firmly
if there is any leakage.If the inlet water pressure is high,only
partially open the tap to reduce the pressure to the washer. Refer
to the allowable inlet pressures on page 28. High or low pressures
may cause a malfunction.
Caution
• Do not install the washer
outdoors, or where
where it is directily exposed to sunlight, wind, rain, etc.
• Plug the power cord of this washer into a properly installed 240 volt 50Hz. power point that is switched & earthed.
• Permissible water temperature : Max 60˚C(140˚F)
• Permissible water pressure : Max 87 psi (600 kPa, 6.0 kg/cm
2
), Min 7.2 psi (50 kPa, 0.5 kg/cm
2
)
• If water temperature &pressure is greater than above,it may cause damage to the machine. If you have uncontrolled
water temperature &pressure you should fit a temperature &pressure relief valve to ensure that water temperature
&water pressure remains within the safe limits.Consult a plumber or electrician if you are unable to adjust water
temperature and pressure.
• Do not over tighten the coupling nuts with a tool.The Inlet valves have a plastic thread. : Do not strip or crossthread.
NOTE
• To prevent syphoning, the drain hose should not extend more
than 50 mm from the end of the hose guide.
• The discharge height must be approximately 0.9~1.2m from
the floor.
Pick
Insert holder
Loading ...
Loading ...
Loading ...