CMXEOCG472 Owner's Manual

Loading ...

INSTALL THE SAFETY REVERSAL SYSTEM

(CONTINUED)

WIRE THE SAFETY REVERSING SENSORS

If your garage has pre-installed wiring for the safety reversing

sensors, see OPTION B - PRE-WIRED INSTALLATION.

OPTION A - INSTALLATION WITH NO PRE-WIRING

1. Run the wire from both sensors to the garage door opener.

Attach with staples, but DO NOT puncture the wire.

2. Separate the sensor wires and strip insulation from each

end. Twist the two white wires together. Then twist the two

white/black wires together.

3. Using a screwdriver, push in the terminal tabs, and insert

the white wires into the white terminal. Insert the

white/black wires into the grey terminal.

OPTION B - PRE-WIRED INSTALLATION

If your garage already has wires installed for the safety reversing

sensors, follow the instructions below:

1. Cut the sensor wires, making sure there is enough wire to

reach the pre-installed wires from the wall.

2. Separate the sensor wires and strip insulation from each

end. Choose two of the preinstalled wires and strip

insulation from each end. Choose the same color pre-

installed wires for each sensor.

3. Connect the pre-installed wires to the sensor wires with

wire nuts making sure the colors correspond for each

sensor.

4. At the garage door opener, strip the end of the wires

previously connected to the sensors. Twist the like-colored

wires together.

5. Using a screwdriver, push in the terminal tabs, and insert

the wire color connected to the sensor’s white wire into the

white terminal. Insert the other wire color connected to the

sensor’s white/black wire into the grey terminal.

Option A

Staple

HARDWARE

7/16” (11 mm)

Wire channel

Insulated Staple (Not Shown)

WHITE

GREY

Option B

Pre-installed

wires

Safety reversing sensor wires

gnisrever ytefaS

sensor wires

White

White/Black

Pre-installed wires

Yellow

Purple

7/16” (11 mm)

Wire nuts (not provided)