Loading ...
Loading ...
Loading ...
INSTALL THE SAFETY REVERSAL SYSTEM
(CONTINUED)
DOOR TRACK INSTALLATION
1. Slide the curved arms of the sensor bracket around the edge
of the door track. Snap into place so that the sensor bracket
is flush against the track.
2. Slide the hex screw through the sensor.
3. Attach the sensor to the bracket with the wing nut. Make sure
the lens is not obstructed by the bracket.
Repeat the steps with the other sensor on the opposite door track.
Both lenses must face each other.
WALL OPTION
Make sure the brackets on each side are clear of the door track and
have the same amount of clearance so the sensors will align
correctly. If additional clearance is needed, use extension brackets
041A5281-1 (not provided) or wood blocks.
1. Attach the sensor bracket against the wall with two lag
screws (not provided).
2. Slide the hex screw through the sensor.
3. Attach the sensor to the bracket with the wing nut. Make sure
the lens is not obstructed by the bracket.
Repeat the steps with the other sensor on the opposite side of the
garage door. Both lenses must face each other.
FLOOR OPTION
1. Measure the position of both sensor brackets so they will be
the same distance from the wall and unobstructed.
2. Attach the bracket to the floor with concrete anchors (not
provided).
3. Slide the hex screw through the sensor.
4. Attach the sensor to the bracket with the wing nut. Make sure
the lens is not obstructed by the bracket.
Repeat the steps with the other sensor on the opposite side of the
garage door. Both lenses must face each other.
Door Track Installation
Door track
Figure 1
Figure 2
Figure 3
Garage door
6" (15 cm) max.
Wing nut
Hexagonal Screw 10-24 (2)
HARDWARE
Wing Nut 1/4"-20 (2)
Wall Option
OR
1
Wing Nut
OPTIONAL
2 3
Door track
Inside
garage wall
6" (15 cm)
max.
Not provided
Floor Option
1
3
4
2
Inside
garage wall
Not
provided
Door track
6" (15 cm) max.
Wingnut
Loading ...
Loading ...
Loading ...