Loading ...
Loading ...
Loading ...
7
13
STEP 13: (SEE FIGURE 11)
• Tighten all bolts and nuts except for those shown in
step 9 that fasten the control bracket to the hitch tube.
STEP 14: (SEE FIGURE 14)
• Slide a spacer (27), a 1/2” washer (35), and the drive
wheel (2) onto the square end of the axle.
• Slide a 1/2" washer (35) over the axle and secure the
wheel with a 1/8 x 1-1/4" cotter pin (29), spreading the
ends.
27
35
35
29
2
14
15
29
35
35
27
3
STEP 15: (SEE FIGURE 14)
• Slide a spacer (27), a 1/2” washer (35), and a wheel
(2) onto the round end of the axle.
• Slide a 1/2" washer (35) over the axle and secure the
wheel with a 1/8 x 1-1/4" cotter pin (29), spreading the
ends.
STEP 16: (SEE FIGURE 15)
• Set the adjustable stop at "5" and move the control
handle back against it.
• Slide the control bracket along the hitch tube until the
ow plate in the bottom of the hopper is open half way.
• Tighten the bolts and nuts fastening the control bracket.
Do not deform the control bracket.
• Make sure the ow plate will open and close all the
way. Readjust if necessary.
1
2
3
4
5
6
7
8
9
10
"5"
OFF
16
Loading ...
Loading ...
Loading ...