Loading ...
Loading ...
Loading ...
5
STEP 5: (SEE FIGURE 5)
• Slide the spreader impeller (9) onto the spreader
shaft and secure it with a 1/8” x 1-1/2” cotter pin (30).
5
9
30
STEP 6: (SEE FIGURE 6)
• Place the hopper on the hopper support tubes, inserting
the spreader shaft through the square hole in the bottom
of the hopper.
• Slide the hopper bushing (39) onto the spreader shaft
and insert it into the bottom of the hopper.
• Slide the spacer (25) onto the spreader shaft.
• Install the agitator hairpin (31) in the spreader shaft.
6
31
25
39
1
STEP 7: (SEE FIGURE 7)
• Attach the hopper to the lower set of holes in the hopper
support tubes using four 1/4” x 1-3/4” hex bolts (23), 1/4”
washers (34), nylon washers (33) and 1/4” nylock nuts
(32). Tighten.
7
23
32
34
33
34
33
23
32
32
STEP 8: (SEE FIGURE 8)
• Install the grip (42) onto the ow control arm.
• Assemble the adjustable stop (44) to the ow
control bracket using the 1/4” x 3/4” carriage bolt
(24), nylon washer (33) and wing nut (43). Tighten.
8
43
42
33
13
44
24
Loading ...
Loading ...
Loading ...