Loading ...
Loading ...
Loading ...
6
FIGURE 8
STEP 9: (SEE FIGURE 9)
• Attach the ow control bracket to the hitch tube
using two 1/4” x 1-3/4” hex bolts (23), four 1/4”
washers (34) and two 1/4” nylock nuts (32). Do not
tighten completely.
9
32
23
34
34
STEP 10: (SEE FIGURE 10)
• Install the end of the ow control rod (10) with no
hole into the elongated hole in the ow plate on the
bottom of the hopper. Lock the rod in the ow plate
by rotating the rod.
10
10
STEP 11: (SEE FIGURE 11)
• Swing the ow control rod around and insert the end
of the rod into the ow control arm. Secure it with a
1/4” washer (34) and a 3/32” x 3/4” cotter pin (28).
11
28
34
STEP 12: (SEE FIGURE 12)
• Fasten the hopper braces (8) to the hopper support
tubes using two 1/4” x 1-3/4” hex bolts (23), 1/4” washers
(34), nylon washers (33) and 1/4” nylock nuts (32). Do
not tighten completely.
• Fasten the loose ends of the hopper braces to the
hitch tube using a 1/4” x 2” hex bolt (22) and a 1/4”
nylock nut (32). Do not tighten completely.
12
23
32
32
32
22
34
33
8
8
Loading ...
Loading ...
Loading ...