Loading ...
Loading ...
Loading ...
6
5. Move your right hand tothe positionshown at the right,
and hold the treadmillfirmly. Using your lefthand, liftthe
Storage Latch (110). Raise the treadmilluntilthe locking
pin snaps intothe Storage Latch. Make sure that the
locking pin is inside the Storage Latch, and that the
Storage Latch is fully closed.
6. See drawing 6B. Attach a Base Pad (95) tothe bottom of
the Stabilizer Plate (81) in the indicated location.
See drawing 6A. Stand behindthe t_eadmiU.Hold the Left
Crossbar Bracket (3) and the Right CrossbarBracket (not
shown). Place one foot on the Base (73) in the indicated
location. Tip the treadmill back slightly.While the tread-
millis held in this position,a second person shouldslide
the Stabilizer Plate (81) onto the Base (see drawing 6C).
Keeping your foot on the Base, carefully tip the treadmill
up until it is resting on the Base. Make sure thatthe
Stabilizer Plate (81) stays on the Base.
See drawing 6C. Attach the Stabilizer Plate (81) to the
Base (73) with a Stabilizer Plate Bolt(91), two Stabilizer
Plate Washers (66), and the Stabilizer Plate Nut (89) as
shown.
.
Refer to assembly drawing5 at the top of this page. Hold
the upper end of the treadmill withyour right hand as
shown. Using your left hand, lift the Storage Latch (110).
Pivot the treadmill slightlyuntilthe lockingpin isout of the
Storage Latch.
Hold the treadmill firmly with bothhands, and lowerthe
treadmill to the floor. To decrease the possibility of in-
jury, bend your legs and keep your back straight.
8. Remove the paper backing from the Wrench Clip (26).
Press the Wrench Clip ontothe Frame (49) in the indi-
cated location. Press the Allen Wrench (83) intothe
Wrench Clip.
6
6A
6B
"_--'-'-- 73
WvJ
7
83 49
l
Loading ...
Loading ...
Loading ...