Loading ...
Loading ...
Loading ...
SWEEPING - The fanning action of the
rotating line can be used for a quick and
easy clean up. Keep the line parallel to
and above the surfaces being swept and
move the tool from side to side.
CUSTOMER RESPONSIBILITIES
Sweeping .
CARE & MAINTENANCE TASK WHEN TO PERFORM
Check for Loose fasteners and parts Before each use
Check for damaged or worn parts Before each use
Clean unit and Iabets After each use
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive full value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
wilI need to be made periodically to
properly maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Housing Screws
• Assist HandIe Screws
• Debris Shietd
CHECK FOR DAMAGED OR
WORN PARTS
Refer replacement of damaged/worn
parts to your Sears Service Center.
• Trigger Switch - Ensure switch func-
tions property by pressing and reIeas-
ing the trigger switch. Make sure mo-
tor stops.
• Debris Shield - Discontinue use of
unit if debris shieId is damaged,
CLEAN UNIT & LABELS
• Ctean the unit using a damp cloth
with a mild detergent.
• Wipe off unit with a clean dry cloth.
REPLACING THE LINE
• Remove the spool by firmly pulling on
the tap button.
• Clean entire surface of hub and spool.
• Replace with a pre-wound spool
(# 71-85837), or cut a length of 30
feet of .065" (1.6 mm) diameter
Craftsman® Trimmer line. Use of
heavier lines could overload the unit
and damage unit. Never use wire,
rope, string, etc., which can break off
and become a dangerous missile.
• Insert one end of line about 1/2 inch
(1 cm) into the small hole inside spool.
• Wind the line evenly and tightly onto
the spool, Wind in the direction of the
arrow found on the spool.
• Push the line into the notch, leaving 3
to 5 inches (7 - 12 cm) unwound.
Hub
Line exit ho}e
• insert the line into the line exit hole in
the hub as illustrated.
• Align the notch with the line exit hole.
• Push the spool into the hub until it
snaps into place.
• Putt the line extending outside the
hub to release it from the notch.
Loading ...