Loading ...
Loading ...
Loading ...
ADJUST THE HANDLE
WARNING:When adjusting the
handle, be sure it remains between the
trigger and the safety label.
• Loosen wing nut or knob on handle.
• Rotate the handIe on the tube to an
upright position; retighten wing nut.
KNOW YOUR TRIMMER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourseif with the location of
the various controls and adjustments. Save this manual for future reference,
Motor
Housin_
Assist
Cord Retainer
Pigtail
PIug
Trigger Switch
Semi-automatic
Head with 065" _ine.
Debris Shield
Line Umiter
PIGTAIL PLUG
The pigtail plug is where you attach
your extension cord to the unit.
TRIGGER SWITCH
The trigger switch is used to turn on the
unit. Squeeze the trigger switch to op-
erate the unit.
LINE LIMITER
The line timiter cuts the cutting line to
the proper cutting length.
ASSIST HANDLE
The assist handte is used to help hold
and guide the unit.
SEMI-AUTOMATIC HEAD
The semi-automatic head holds cutting
line and rotates during operation.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified
on your unit.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
Length of Cord Gauge
25 Ft, t8 Gauge
50 Ft. t6 Gauge
100 Ft. t6 Gauge
Extension cords are available for this unit.
ATTACH THE EXTENSION
CORD TO YOUR TRIMMER
Loop extension cord through the han-
dle and around hook. Insure the pIug
and cord are firmly and fully engaged.
CORRECT OPERATING POSITION
Stand as shown and check for the fol-
lowing:
• Operator wearing eye protection and
heavy clothing.
• Right hand holding handle.
• Unit below waist level
• Use the left side for trimming so de-
bris is thrown away from the operator,
Without operator bending over, keep
the line near and paraIlel to ground
and not crowded into material being
cut,
Loading ...
Loading ...
Loading ...