Miele PWM 908 [EL DP] Operating and Installation Instructions

Loading ...

Supervisor level

Automatic dispensing

Automatic dispensing via an external

dispensing system can be activated

Factory default: Off

Adjustment value dispensing 1–6

To address the tolerances that occur

in the pump system over time, the dis-

pensing amount (ml/min) for the

pumps can be corrected.

The calibration value can be reduced by

3increments or increased by 3incre-

ments.

The calibration value is increased or re-

duced by 1, 2 or 3 times the adjustment

value based on the selected incremen-

tal setting.

The calibration value and the adjust-

ment value must be added to the data

for the dispenser pumps by Miele Cus-

tomer Service.

Peak load signal

External hardware is connected via the

Miele XCI Box.

The peak-load negotiation function

enables the washing machine to be

connected to an energy management

system. When a signal is registered,

the washing machine’s heater is

switched off for a short period.

The washing machine may only be op-

erated with a peak-load system if this

system is connected to the washing

machine via the Miele XCI Box.

- No function (factory default)

- Peak load with 230V

- Peak load with 0V

- Com module

Peak load prevention

The peak-load negotiation function

can be deactivated with disinfection

programs. When a signal is registered,

the washing machine’s heater is not

switched off.

Factory default: Off

Loading ...

Miele PWM 908 [EL DP] Professional Washing Machine

Operating and Installation Instructions - Page 95