Loading ...
Loading ...
Loading ...
Yourcleaningsystemrequiressomeassemblyandisready
foruseonlyafterit hasbeenproperlyservicedwiththe
recommendedoilandfuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHE PRESSUREWASHER
1. Remove everything from carton except pressure washer.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents. If any parts are missing or damaged,call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handlewith CleaningTank Assembly
• Accessory Tray
• High PressureHose
• Spray Gun
• NozzleExtensionwith Ouick Connect Fitting
• HydroFoamTM Wash
• Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Safety Goggles
• Bagcontaining 3 multi-colored ProjectProTM Nozzles
• HydroFoamTM Launcher
• HydroFoamTM Launcher & Wash Instruction Sheet
• FreshStart Fuel Cartridge
• HandleFasteningHardwareKit (whichincludes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGCLEANIHGSYSTEM
Your Craftsman cleaning system wiil needassembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergentsiphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attachquick connect ProjectProTM nozzleto nozzle
extension.
Attach Handle and Accessory Tray
1. Placehandle assembly onto handlesupports connected
to main unit. Makesure holes in handle align with holes
on handlesupports.
Handle
Supports /
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob from inside of unit. Tighten by
hand.
%.
3. Placeaccessory tray over holes on handle (viewing from
front of unit). Push tree clips into holes until they sit flat
against accessory tray.
4. Insert multi-colored ProjectProTM nozzlesand other
supplied accessories in spaces provided in accessory
tray. See "How to UseAccessory Tray".
Loading ...
Loading ...
Loading ...