Loading ...
Loading ...
Loading ...
ADJUSTING THE CUTTING HEIGHT
_, WARNING: Failure to unplug your router before performing adjustments
to the router or table could result in accidental starting causing serious injury.
Select correct holes to adjust the cutting height for your router according to
Table 2 and Fig. 14.
NOTICE: A hex wrench (not supplied) is required for this operation.
1. Turn off the table switch by pushing the ON/OFF switch panel.
2. Loosen the clamping lever on
the router.
3. Insert the hex wrench (not
supplied) into the adjusting hole
on the tabletop (Fig. 29), and
turn the router adjustment dial
with the hex wrench to move
the router collet up or down.
4. When the desired cutting
height is set, tighten the
clamping lever on the router.
USING THE ROUTER WITH THE ROUTER TABLE
1. Read and understand the entire Operator's Manual for the router.
2. Always plug the router into the switched outlet in the router table. Never
plug a router table mounted router into another power source.
3. Make sure that the router-table switch is off.
4. Plug the router-table cord into a power source.
5. Turn on the power to the router table by lifting up the on/off switch panel.
6. Always control the power to the router with the router-table switch
whenever the router is mounted on the table.
ROUTING OPERATION
1. Read and understand the entire Operator's Manual for the router.
2. Adjust the fence to support the workpiece to be cut.
NOTICE: The workpiece must always be held tight against the fence.
3. Reconfirm that all router adjustments are securely locked before supplying
power to the router.
4. Note that the direction of rotation of the router mounted to a router table is
counterclockwise. Feed the workpiece from right to left.
WARNING: The direction of feed for the workpiece is always against the
sharp edges of the cutter and into the rotation of the cutter (the cutter rotation is
counterclockwise when the router is installed in a router table). Failure to follow
this rule can result in serious personal injury.
37610 Manual_Revised_12 1221 Page 29
Loading ...
Loading ...
Loading ...