Loading ...
Loading ...
Loading ...
Attach the feather board to the tabletop surface
1.
2.
3.
4.
5.
Take apart the feather board locking knobs.
Slide the square-neck bolts into the slots of the tabletop (H).
Place the feather board (L)
on the tabletop surface as Fig. 21a
i
shown in Fig. 21a.
Slide a plain washer onto
the bolt.
Place the clamping knob onto
the bolt, from underneath of
the table, depress the square
neck of the bolt into the slot
and tighten the clamping
knob clockwise to secure the
feather board (L) to the fence.
H
I Square-neck
_/bolt
To remove the feather board
1. Loosen the clamping knobs; slide the feather board into the hole in the miter
gauge slot.
2. Pull the feather board up to remove it.
iNSERTiNG THE STARTING i Fig. 22 i
PiN (Fig. 22) V
,_ WARNING: Make sure that Z
the router is not plugged into
a power outlet when installing
into the table, removing from
table, making any adjustments or
changing accessories.
Thread the starting pin (V) into the
hole designated "Z" in Fig. 22 on
the right of the mounting plate.
Use the starting pin as a pivot
point when cutting small, odd-shaped pieces.
NOTICE: Only use piloted cutters when using the starting pin. Place the starting
pin into the hole designated "Z" in Fig. 22 on the right of the mounting plate inset
opening, and secure it by turning it clockwise.
Page 24 37610 Manual_Revised_12 1221
Loading ...
Loading ...
Loading ...