Loading ...
Loading ...
Loading ...
PAGE: 6 / 12
Move ground wires (a), outlet box wires (b), and motor
wires (c) away from the center of the hanger bracket.
Then slide receiver through hanger bracket as shown.
Antenna end first, until it is centered. Finally, cut motor
wires (c) to length needed for connections.
Fig.10
Code example:
1-ON 2-OFF 3-ON 4-OFF on both DIP
Switches.
Note: If you have two ceiling fans with
2 remote control units, set 2 different
codes for each set of transmitter / receiver.
Fig.10a
(For downrod mount only):
Hang the fan on hanger bracket, and
make sure the slot of hanger ball is
snapped into the chip of hanger
bracket exactly.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket face down.
(For downrod mount only):
Tighten the two collar screws.
Slide lock pin into hanger pin until
it is locked into position.
Fig.8
Lock Pin
Collar Screws
Fig.9
Slot
Chip
Hanger Bracket
There is a code switch in the transmitter
and receiver. This "DIP Switch" is a 4 key
unit (Fig.10). All keys were set at "ON"
position in the beginning. Set the keys to
a different code. Make sure the same
numbered keys are switched "ON" for
both DIP Switches (Fig.10a). Take note
that the "ON" position may have different
orientation in each.
Fig.11
201202
Loading ...
Loading ...
Loading ...