Loading ...
Loading ...
Loading ...
Cleaning the Appliance (Continued)
AUTOMATIC LOCK OFF OF THE SURFACE ELEMENTS (30" models with a self-cleaning oven only)
During the self-clean cycle, the surface elements, when used, are subjected to high heat. Toensure maximum element life, a safeguard
locks off the use of the surface elements during the self-clean cycle. Once the oven cleaning cycle iscomplete and the oven door can be
opened, the surface elements can be utilized.
What to Expect During Cleaning
While the oven is in operation, the oven heats to temperatures much higher than those used in normal cooking. Sounds of metal
expansion and contraction are normal. Odor isalso normal asthe food soil isbeing removed. Smoke may appear through the oven
vent, located on the top of the control panel.
If heavy spillovers are not wiped up before cleaning, they may flame and cause more smoke and odor than usual. This is normal
and safe and should not cause alarm. If available, use an exhaust fan during the self-cleaning cycle.
NOTE: A smoke eliminator in the oven vent converts most of the soil into a colourless vapor.
Setting the Controls for a Clean Cycle
For the setting of the clean cycle, refer to the section on the timer or Electronic oven control.
To Remove and Replace the Oven Door
1. Open the door fully.
2. Pull up the lock located on both hinge supports and engage them in the hook of the hinge levers. You may have to apply a
little downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door bythe sides, pull the bottom of the door up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage
the hinge levers.
4. Proceed in reverse to reinstall the door.
Make surethe hinge supports are fully engaged before unlocking the hinge levers.
in normal
position
O
Lock engaged
for door re-
moval
HINGE SLOT
Door removed
from the range
17
Loading ...
Loading ...
Loading ...