Loading ...
Loading ...
Loading ...
9000989321 Rev A English 7
Note: The universal connector brackets are interchange-
able for the left and right sides of the oven. Be sure the
taller vertical edge of the bracket is positioned to the out-
side of the oven.
5. Install the decorative trim.
6. Place the steam oven unit on top of the universal
connector brackets and fasten in place using two
screws per side. Tighten the screws securely, but do
not overtighten.
Note: The existing screws in the steam oven base help
with alignment. When lowering the steam oven into
place on the universal connector bracket, allow these
screw heads to slide into the slots as shown in the
illustration below. The screw nearest the front of the
steam oven slides into the base of the slope at the front
of the bracket.
7. Continue with the unit installation in the following
sections on electrical connection and installing the
oven unit into the wall cabinet.
Connecting the Microwave Oven or Steam Oven
Electrical Conduit to the Single Oven
Note: If installing the oven with a microwave or steam oven
mounted as a combination unit, the microwave oven or
steam oven power cable must be properly attached to the
oven-mounted junction box. This must be done prior to
supplying electric power to the oven unit.
1. Check to be sure there is no electric power supplied to
the oven.
2. Remove the oven mounted junction box cover (located
on the rear top of the oven).
3. Remove the cap from the conduit access hole in the
side of the oven mounted junction box.
4. Guide the four wires from the conduit cable coming
from the microwave or steam oven through the hole in
the oven mounted junction box.
5. Snap the conduit connector into the hole by pressing it
in until it clicks into place.
6. Follow the wiring diagram label and match and connect
each wire by color to the wires attached to the wiring
block inside the oven mounted junction box. Push the
bare end of the wire until it is snug in the wiring block
then tighten down the retaining screw on each wire.
Tighten securely, but do not over tighten.
7. Replace the oven mounted junction box cover and
tighten the two screws holding it in place. Tighten the
screws securely, but do not over tighten.
Position the decorative trim
piece so the flanges with
the holes in them face
away from the oven door.
Align the inner flanges with
the inside of the universal
brackets. Fasten with one
screw each into the end
hole of the universal
bracket. Tighten screws
securely, but do not
overtighten.
9 WARNING
Disconnect the oven from the electric power supply
before connecting the microwave oven or steam
oven wiring. Failure to do so could result in electrical
shock and injury or death.
Loading ...
Loading ...
Loading ...