Loading ...
Loading ...
Loading ...
Combination Oven Pre-Assembly
English 6 9000989321 Rev A
4. Place the microwave oven unit on top of the universal
connector brackets and fasten in place using three
screws per side. Tighten the screws securely, but do
not overtighten.
Note: The existing screws in the microwave base help
with alignment. When lowering the microwave into
place on the universal connector bracket, allow these
screw heads to slide into the slots as shown in the
illustration below. The screw nearest the front of the
microwave slides into the base of the slope at the front
of the bracket.
5. Continue with the unit installation in the following
sections on electrical connection and installing the
oven unit into the wall cabinet.
Installation with the Steam Oven
Note: Do not place the oven into the wall cabinet until after
mounting the steam oven on it using the universal connec-
tor brackets.
1. Remove the six screws holding the combo service slide
assemblies to the support bracket. Use a magnetic
screwdriver bit to reach the screws through the large
holes in the tops of the slides.
2. The screw in position A (nearest the inside edge, near
control panel) must be moved to allow the universal
bracket to be postioned there. Remove the inside
screw (A) from the left support bracket and reinsert it
into the third hole (B) from the inside edge of the
support bracket. Repeat for the right support bracket.
3. Reattach the slide assemblies using the holes near the
inside edge of the support bracket. Align the slide
assembly parallel to the edge of the bracket and insert
the first screw in hole (C). Insert all three screws for
each slide assembly. Tighten the screws securely, but
do not overtighten.
Note: When the correct holes are used, the front of the
slide assembly will extend just past the edge of the horizon-
tal support bar. The slide assembly will be about 1/8” (3
mm) from the inside edge of the support bracket.
4. Install the two universal connector brackets to the slide
assemblies using the screws provided. Tighten screws
securely, but do not overtighten.
Loading ...
Loading ...
Loading ...