Loading ...
Loading ...
Loading ...
TO iNSTALL SHIFTER LEVER KNOB
@ Thread the shifter lever knob onto the threaded end
of the shifter lever until it is snug against the hex nut
and the lip is pointed toward the engine. Tighten the
hex nut against the bottom o! the shift lever knob (See
Fig. 6).,
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables, Fig_7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
before you use your snow thrower.
For instructionson checking or adjusting the control
cables, see ToAdjust Clutch Control Cables paragraph on
page 20.
TO ASSEMBLE SNOW CHUTE
• Remove three carriage bolts, flatwashers, and nuts
from snow chuteflange.
e Position snow chute on snow chute flange and align
the three holes inthe snow chute with holes insnow
chute flange.
e Replace carriage bolts (from inside of chute) asshown
in FIGo7A. flat washers, nuts and tighten..
_/ CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
SNOW THROWER, WE WISH TO ASSURE THAT YOU
RECEIVE THE BEST PERFORMANCE AND
SATISFACTION FROM THIS QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
#' All assembly instructionshave been completed.
4' The discharge chute rotates freely.
/ No remaining !oose parts in carton_.
WHILE LEARNING HOW TO USE YOUR SNOW
THROWER, PAY EXTRA ATTENTION TO THE
FOLLOWING IMPORTANT ITEMS:
/./' Engine oil is at proper level.
i'v" Make sure gas tank is filied properly with clean, fresh,
unleaded gasoline.
/,/' Become familiar with all controls-their location and
function. Operate controts before starting engine.
LEVER
FIG. 6
T.A'c:noNcLuTC.L E. Au E"CLuTc,LEVER
CONTROL CABLES
FIG.7
LOCKNUTS
FLA'TWASHER
SNOW CHUTE
_,GE
BOLTS
FLANGE
FIG. 7A
9
Loading ...
Loading ...
Loading ...