Loading ...
Loading ...
Loading ...
motor specifications and electricamrequirements
MOTOR SPECiFiCATiONS
This dri!l press is designed to use a 1725 RPM motor
only. Do not use any motor that runs faster than 1725
RPM. It is wired for operation on 120 volts, 60 Hz.
alternating current.
WARNING: To avoid injury from unexpected
startup, do not use blower or washing machine
motors or any motor with an automatic reset
overload protector.
CONNECTING TO POWER
SOURCE OUTLET
This machine must be grounded while in use to protect
the operator from electric shock.
Plug power cord into a 120V properly grounded type
outlet protected by a 15-amp. dual element time delay
or Circuit breaker.
NOT ALL OUTLETS ARE PROPERLY GROUNDED.
iF YOU ARE NOT SURE THAT YOUR OUTLET, AS
PICTURED BELOW, IS PROPERLY GROUNDED,
HAVE iT CHECKED BY A QUALIFIED ELECTRICIAN.
WARNING: To avoid electric shock, do not touch
the metal prongs on the plug, when installing or
removing the plug to or from the outlet.
WARNING: Failure to properly ground this
power tool can cause eiectricution or serious
shock, particularly when used in damp loca-
tions, or near metal plumbing, if shocked, your
reaction could cause your hands to hit the cut-
ting tool.
IF POWER CORD IS WORN OR CUT, OR DAM-
AGED iN ANY WAY, HAVE IT REPLACED IMME-
DIATELY TO AVOID SHOCK OR FIRE HAZARD.
This power tool is equipped with a 3-conductor cord
and grounding type plug, approved by Underwriters'
Laboratories. The ground conductor has a green jacket
and is attached to the tool housing at one end and to
the ground prong in the attachment plug at the other
end.
This plug requiresa mating 3-conductor grounded type
outlet as shown.
If theoutlet you are planning to use for this power tool
is of thetwo prong type, DO NOT REMOVE OR ALTER
THE GROUNDING PRONG IN ANY MANNER. Use
an adapter as shown and always connect the grounding
lug to known ground.
It is recommended that you have a qualified electrician
replace the TWO prong outlet with a properly grounded
THREE prong outlet.
An adapter as shown below is available for connecting
plugs to 2-prong receptacles.
WARNING: The green grounding lug extending
from the adapter must be connected to a
permanent ground such as to a properly
grounded outlet box.
GROUNDING LUG
SCREW \
o ou o
ADAPTER
3-PRONG
PLUG
GROUNDING
PRONG
ALWAYS USE A
PROPERLY GROUNDED
OUTLET
Your unit is for use on ! 20 volts, it has a p_ugthat looks
like the one above.
NOTE: The adapter illustrated is for use only if you
already have a properly grounded 2-prong receptacle.
The use of any extension cord will cause some loss of
power. To keep this to a minimum and to prevent over-
heating and motor burn-out, use the table below to
determine the minimum wire size (A.W.G.) extension
cord. Use only 3 wire extension cords which have 3-
prong grounding type plugs and 3-pole receptacles
which accept the tools plug.
Extension Cord Length Wire Size A.W.G.
0-25 :Feet 16
26-50 Feet 14
51-100 Feet ! 2
Loading ...
Loading ...
Loading ...