Loading ...
Loading ...
Loading ...
POSiTiONiNG TABLE AN{} WORKP_ECE
Lock the table to the coiumn in a position so that the
tip of the drill is just a iittle above the top of the work -
piece,
A_ways place a piece of BACK-UP t_4ATERtAL (wood.
plywood . . .) on the table underneath the wo_kpi_:_ce.
This will prevent "splintering" or making a heavy bur_
on the underside on the workpiece as the drill breaks
through. To keep the backup material from spinning
out of control, it must contact the left side of the coiumn,
as illustrated.
WARNING: To prevent workpiece or the
backup material from being torn from your
hand while driHi_J, position the_'_ against the _eft
side of the eo_um_o _f the workpiece or the
backup materia_ are not tor_g enough to reach
the coBumn, o_amp them to the table° Failure to
do this could result in personal injury_
BACK°U _
MATER_AL
For small pieces that cannot be c_amped to the tabie,
use a dril! press vise (Qptiona! accessory).
WAIRNBNG:The vise must be emamped or bolted
to the table to avoid inju_'y 1'rein spinning
work and vise or tooU breakage,
WORKP_'ECE,
DRILLwsEPRESS
BOLT OR CLAMP
ViSE
TgLTING TABLE
To use the table in a bevel (tilted) position, loosen
the bevel lock with adjustable wrench.
Tilt table to desired angle by reading bevel scale.
Retighten bevel lock.
BEVEL SCALE
19
BEVEL
LOCK
Loading ...
Loading ...
Loading ...