Loading ...
Loading ...
Loading ...
WARRANTY
life of the heater, read the Owner’s Guide and follow the
instructions. Failure to properly maintain the heater will
void any warranty and may cause the heater to function
improperly.
LIMITED THREE YEAR WARRANTY: Cadet will repair
or replace any Com-Pak Bath (CB) heater found to be
defective within three years after the date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2. Damage occurs to the product through improper
maintenance, misuse, abuse, accident, or alteration;
3. The use of unauthorized accessories or unauthorized
components constitutes an alteration and voids all
warranties. Refer to Cadet website or call customer
service at 855.223.3887 or 360.693.2505 for list of
authorized accessories and components.
4. Cadet’s warranty is limited to repair or replacement.
5. In the event Cadet elects to replace any part of your
Cadet product, the replacement parts are subject to the
same warranties as the product. The installation of re-
placement parts does not modify or extend the under-
lying warranties. Replacement or repair of any Cadet
product or part does not create any new warranties.
If you believe your Cadet product is defective, please
contact Cadet during the warranty period, for instructions
on how to have the repair or replacement processed.
Parts and Service
Visit cadetheat.com/parts-service for information on
where to obtain parts and service.
ration
TIMER
MANUAL
RESET HIGH
TEMPERATURE
LIMIT
HEATING ELEMENT
CB
DA
MOTOR
L1 L2
36
14
THERMOSTAT
JUMPER WITH
INSULATED
CONNECTOR
SPARE
TERMINA
L
INTERNAL HEATER WIRING DIAGRAMS
TIMER
MANUAL
RESET HIGH
TEMPERATURE
LIMIT
HEATING ELEMENT
CB
DA
MOTOR
L1 L2
36
14
THERMOSTAT
JUMPER WITH
INSULATED
CONNECTOR
SPARE
TERMINA
L
TIMER
MANUAL
RESET HIGH
TEMPERATURE
LIMIT
HEATING ELEMENT
C
BA
MOTOR
240/208
VOLT
POWER
SUPPLY
L1 L2
36
14
THERMOSTAT
240/208 Volt Power Supply
120 Volt Power Supply
240 Volt Power Supply
1. Make sure all wires are properly
connected and installation is com-
plete before you turn on the heater.
2. Do not operate without grill.
3. Do not tamper with the high-
OPERATING INSTRUCTIONS
7
Complete installation
After installation, turn your heater to the highest setting and let it run for 30 minutes. Some smoking
If your heater shows signs of overheating, such as glowing red or repeatedly getting unusually hot and
or call us.
CB103T MULTI-VOLT
CB132T MULTI-WATT
How to operate your heater
With the thermostat
The room temperature is controlled by a thermostat located on the heater. Once installation is com-
plete and power is on, follow the steps below.
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature,
turn the knob to the right.
With the thermostat knob turned all the way to the left, the heater will not come on, but using the timer
will operate the heater.
To operate the heater with the timer, turn timer knob to desired minutes. The timer cancels thermostat
control while it's running. The heater stays on until time is up, even if your room temperature
becomes warmer than the thermostat setting, then control of the heater returns to the thermostat.
Loading ...