Loading ...
Loading ...
Loading ...
•
• The Com-Pak Bath can only be mounted with the element up. It cannot be mounted in the ceiling or
24" (61 cm) from the ceiling.
• For cleaner performance and longer heater life, install your heater 12 inches (30.5 cm) from the
• All models can be installed to be Americans with Disabilities Act (ADA) compliant. Check your state
• A wall thermostat cannot be used with this heater.
• The wall can label arrows show the correct mounting orientation (arrows must point up).
If you haven’t installed drywall yet, make sure the front of the wall can extends beyond the front edge of
the wall stud to match the drywall depth (See Figure 2).
Fasten the wall can to the stud with two screws through holes provided in the wall can (See Figure 2).
to the stud.
STEP 3
Mount the wall can
STEP 1
Cut a hole in the wall next to a wall stud
PARED
ADYACENTE
¾"
(1.9 cm)
Min.
ADJACENT
WALL
¾"
(1.9 cm)
Minimum
attach foam pad here
STEP 2
Locate or route electrical supply wires
Route the electrical supply wire from the circuit breaker to the heater location.
Remove a knockout from the wall can (best location is closest to heater wires) and attach the supply
wire with a cable clamp connector (not included) leaving a minimum of 6 inches (15.2 cm) wire lead
(See Figure 2).
INSTALLATION INSTRUCTIONS
View from top of wall can
If you haven’t installed drywall yet, skip this step.
TIPS BEFORE YOU BEGIN
front of wall can extends beyond front
edge of wall stud to match drywall depth
drywall
wall
stud
twist with screwdriver
to remove one of the
knockouts
attach supply wire
with a cable clamp
connector
fasten with 2
wood screws
4
Loading ...
Loading ...
Loading ...