Loading ...
Loading ...
Loading ...
E
1
And install I or J to Pa E.
(Tighten the screws on both sides.
We suggest to tighten the screws on
the side ① rst, and then tighten the
screws on the side ② )
2
Adjust the tightness.
Plug in.
Put the cup in Pa E.
Shaped cup
Replace Baking Coaster
I or J
E
①
②
14
Ⅲ.Printing methods
Ⅳ. Trouble shooting for transfer quality
Pale Color:The temperature is too low/the pressure is not correct/or not pressed long enough.
Blurring Pattern:Too much transfer time causes proliferation.
Pa Blurring of Pattern:Heat was not distributed correctly through heat plate.
Allow more time between press operations.Pressure distribution can also be the cause,which can be set
on the four plate suace adjusters.Please note that it has been facto set and there should be no need
to adjust them.
Dull Suace of Pattern:The pressure is too lager or the temperature is too high.
Scarred Pattern:Transfer time is too long.
Dierent Pattern Color:The pressure is not correct or the transfer paper is poor quality.
Adhesive Paper:the temperature is too high or poor printing ink.
Adjust pressure to your requirement (Neither too tight nor too loose),
Plug in the power cord and turn the power switch ON.
The temperature stas to rise.Set the Initial temperature,Highest Temperature an press time.
Once the temperature rise to the Initial temperature,the buzzer will send out a shot “BEEF” sound.
Press the button once.Then Place the object (i.e. T shi) on press bed.Pull down the handle to press
the object.
Wait for the time ends up with a long buzzer sound.(Note: There will be about 5s time for long buzzer to
notify you it has nished,and after that will appear 5s for shobuzzer to notify you whether you still go
on the next work,if not the temperature will fall down to the Initial temperature )
Work nish and take out object.
Turn o the power switch.
15
Loading ...
Loading ...