Loading ...
Loading ...
Loading ...
37
Just Power On
040
Inverter Output Short
Circuit
Please disconnect the load to make sure the
load has been connected properly.
Click to clear the alarm history.
041 Network Address Error
Please reset the “Master”unit or “Slave”unit.
Click to clear the alarm history or reboot the
unit.
042
Network Communication
Error
Reconnect the communication wire again.
Please reset the “Master”unit or “Slave”unit.
Click to clear the alarm history or reboot the
unit.
043 Grid Phase Failure
Check the input wire and whether the “Master”
unit or “Slave”unit can work well.
044 Network Sync Error
Reconnect the communication wire again.
Please reset the “Master”unit or “Slave”unit.
Click to clear the alarm history or reboot the
unit.
045 PFC Error
Check whether the grid works well.
Please contact with the dealer if the error still
exists after rebooting the unit.
046 Grid Input Over Current
Check whether the EP500 is on.
Disconnect the loads on the grid or EP500.
Check whether the Max. Grid input current
could work well with strips or your Air
Breaker.
049 SPI Communication Error
Please contact with the dealer if the error still
exists after rebooting the unit.
050
BMS Communication
Error
Please contact with the dealer if the error still
exists after rebooting the unit.
051 EEPROM Read_write Error
Please reset the congurations on “Settings”.
Please contact with the dealer if EP500 have
not been recovered after rebooting.
052
DSP Parameter
Misconguration
Please reset the congurations on “Settings”.
Please contact with the dealer if EP500 have
not been recovered after rebooting.
057 BMS Temperature Error
Please store EP500 at the recommended
temperature and leave it until the temperature
inside back to the normal standard.
Loading ...
Loading ...
Loading ...