Loading ...
Loading ...
Loading ...
ASSEMBLY
Your new tractor has been assembled atthe factory with exception of those parts left unassembled for shipping purposes. To
ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Pliers (1) Tire pressure gauge
(2) 9/16"wrench (1) Utility knife
(1) 1!2"wrench (1) 3/4" socketw/drive ratchet
When right orleft hand is mentioned in this manual, itmeans
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
Remove all accessible loose parts and parts cartons
from carton.
Cut, from top to bottom, along lines on all four corners
of carton, and lay panels flat.
Remove mower and packing materials.
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
Remove hex bolt, Iockwasherand large flatwasher from
steering shaft.
Position front wheels of the tractor so they are pointing
straightforward.
Slide the steering sleeve over the steering shaft.
Align tabs and press steering sleeve extension into
bottom of steering wheel.
Position steering wheel so cross bars are horizontal (left
to right) and slide onto steering wheel adapter.
Secure steering wheel to steering shaft with hex bolt,
lock washer and large flat washer previously removed.
Tighten securely.
Snap steering wheel insert into center ofsteering wheel.
Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRESWHERE TRACTOR
IS TO ROLL OFF SKID.
STEERING WHEEL
INSERT
___---_LHEX BOLT
OCK WASHER
(_---_LARGE FLAT WASHER
SLEEVE EXTENTION
STEERING /J
SHAFT
STEERING'
SLEEVE _ ,/ _\
FIG. 1
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY (See Fig. 2)
Lift hood to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in CUSTOMER RESPONSIBILITIES
section of this manual for charging instructions).
LABEL
FIG. 2
6
Loading ...
Loading ...
Loading ...