Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
KEPS NUT SPRING BUSHING
TERMINAL
ACCESS
DOOR
HEX BOLT
POSITIVE
CABLE
TERMINAl
GUARE
(BLACK)
CABLE
FIG. 32
TO REPLACE HEADLIGHT BULB
Raise hood.
Pull bulb holder out ofthe hole inthe backside ofthe gdll.
Replace bulb in holder and push bulb holder securely
back intothe hole inthe backside of the grill.
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to ran
poorly, stop running, or prevent itfrom starting.
Check wiring. See electrical wiring diagram inthe Repair
Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The fuse
holder islocated behind the dash.
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 33)
While holding spring bushing with wrench, loosen jam
nut.
Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments.
Turn adjustment bolt counterclockwise for lighter at-
tachments.
Retighten jam nat against spring bushing.
IMPORTANT: DO NOTADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER, ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION.
ADJUSTMENT
BOLT
®
®
JAM NUT
FIG. 33
ATTACHMENT
LIFT SPRING
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 34)
Raise hood.
Unsnap headlight wire connector.
Stand infront of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 34
25
Loading ...
Loading ...
Loading ...