Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
FOR SWEEPER
TOOLS REQUIRED
(1)
(1)
(1)
(1)
(1)
(1)
(1)
HOUSING
Adjustable Wrench
3/8" Open End or Box Wrench
7/16" Open End or Box Wrench
1/2" Open End or Box Wrench
9/16" Open End or Box Wrench
Standard Screwdriver
Pair of Pliers
NOTE
Right Hand (RHo) and left hand (L.H.)
are determined from operator's
position while seated on tractor.
HITCH BRACKET
POSITION SEE
GROUP "B '°
PAGE 10
TOP VIEW
3/8" x 1-1/2"
HEX BOLT
(BACK HOLE}
3/8" x 1"
HEX BOLT
FRONT HOLE)
HITCH BRACKET
;23._------ POSITION SEE
,/_ GROUPS "A"
_ PAGE 10
Refer to carton contents figure on page 2 and figure
1 on page 3 for parts and hardware needed to
assemble sweeper housing,
1o Assemble the hitch bar too the sweeper
housing; place hitch bar under sweeper
housing as shown in figure 3,
2. Secure hitch bar with two 3/8" x 1" hex bolts
and 3/8" lock nuts, See figure 3. Do not tighten
at this time.
3/8" HEX LOCK NUT
\,
\
\,
, \
3/8" x 1" HEX BOLTS
,\\
BAR ._ ',
SWEEPER HOUSING
FIGURE 4
BOTTOM VIEW
HITCH
HITCH
3/8"'
LOCK NUTS
LARGE FLAT
WASHER
BRACE ROD
FIGURE 5
NOTE
FIGURE 3
NOTE
Before assembling the hitch bracket
or hitch pin bracket to the hitch bar
refer to figures 4, 7 and page 10 to
determine which position is required
for your Sears riding mower or tractor.
3 Assemble the hitch bracket to hitch bar with one
3/8" x 1" hex bolt (in the front hole) and 3/8"
hex lock nut. Do not tighten at this time. See
figure 4,
4. Assemble the hitch bracket with one 3/8" x
1-1/2" hex bolt (in the back hole), large ftat
washer and 3/8" hex lock nut. (Do not tighten
at this time). See figures 4 and 5.
4
Cut, the plastic tie down holding
height adjustment lever.
5_,
Assemble the two bag mount arms and top
ends of brace rod. See figure 6, Assemble the
top hole in arms to sweeper housing using two
3/8" x 3/4" hex bolts and 3/8" lock nut& The
notched side of mount arms face upward and
mount on the inside of housing. See figure 6,
Assemble the brace rod under hitch bar and
large washer in back hole of hitch bracket, then
assemble brace rod ends to bottom holes in
arms and sweeper housing, using two 3/8" x
1-1/4" bolts, 3/8" flat washers and 3/8" hex
lock nuts, See figures 5 and 6 Do not tighten
as this time.
Loading ...
Loading ...
Loading ...