Loading ...
Loading ...
Loading ...
REPETITIVE CUTTING
REPETITIVE CUTTING is known as cutting a
quantity of pieces the same length without having to
mark each piece,
t Use the Stop Rods (optional accessory) only for
cutting duplicate pieces 6 in, long and longer
2. Follow all safety precautions and operational
instructions for cross cutting
When making repetitive cuts from a long workpiece,
make sure it is adequately supported
Use the Hold-Down Clamp (Optional Accessory) on
the miter gauge for greater-accuracy.
\
i. NEVER USE THE RIP FENCE AS A LENGTH STOP
BECAUSE THE CUT OFF PIECE COULD BIND
BETWEEN THE FENCE AND THE BLADE CAUS-
ING A KICKBACK
2 When making repetitive cuts shorter than 6 in., clamp
a block ol wood 2 in long to the table to act as a length
stop.. Do not clamp directly to the bottom edge of the
table because the swivel of the clamp will not grip
properly Place a small blcok of wood between the
bottom edge of the table and the "C" clamp.,
CAUTION: When clamping the block, make sure
that tile end of the block is well in front of the
sawblade. Be sure it is clamped securely.
3. Slide the workpiece along the miter gauge until it
touches the block .... hold it securely or' clamp it with
the Hold-Down Clamp (Optional Accessory)
,RY FENCE/
WORK SUPPORT
/
', .... i i
MITER CUTTING
MITER CUTTING is known as cutting wood at an
angle other than 90° with the edge of the wood
Follow the same procedure as you would for cross-
cutting.
Adjust the miter gauge to the desired angle, and lock
it
The miter gauge may be used in either of the grooves
in the table.
When using the miter gauge in the LEFT hand
groove, hold the workpiece firmly against the miter
gauge he_id with your left hand, and grip the lock
handle with your right,
When using the RIGHT hand groove, hold the
workpiece with your right hand and the knob with
your' left hand
Use the Hold-Down Clamp (Optional Accessory) on
the miter gauge for greater accuracy,
\
BLOCK
4, Make th_ cut ......turn the saw oil .... remove the piece
after the blade has stopped and before cutting the
next piece
30
Loading ...
Loading ...
Loading ...