Loading ...
Loading ...
Loading ...
16 Make two folds in a small piece (6 x 6 in ) of
ordinary NEWSPAPER making three thicknesses
The folded paper will be used as a "spacing
gauge",
I
17. Place RIP FENCE on table _...
CAREFULLY move it against blade so that it is
parallel to the blade, and just TOUCHES tips of saw
teeth.., tighten RIP FENCE LOCK LEVER
18. Insert folded paper between SPREADER and
FENCE,
19, Using a 7/16" wrench, loosen the 1/4-20 hex head
screws so the spreader can slide sideways.
2Q Hold spreader flat against fence tighten screws
using 7/16" wrench.
21. To remove BLADE GUARD and SPREADER, loosen
THUMBSCREW .... DO NOT LOOSEN OTHER
SCREWS, This lets you remove and replace the
guard without disturbing the spreader alignrnenL
7/16 IN. WRENCH
\
FOLDED PAPER
;ETSCREW
MOUNTING THE MOTOR
1 Put the motor mounting base against the flat surface
of a workbench,
2 Position the motor so the Shaft is facing away from
you,
3. Loosen both cradle clamp screws.
4 Put a square against the LEFT side of the motor and
against the top of the workbench.
5 Turn the motor inside the cradle clamps until the top
of both capacitors touch the square.
6. Tighten both cradle clamp screws to hold the motor
in this position.
WARNING: The motor must be properly attached.
Otherwise, the workpiece can hit the motor during
45° bevel cuts,
LOOSEN BOTH CRADLE CLAMP SCREWS
:,z __
CA O'TORS t._. MOTOR
IMOTOR MOUNTING
BASE
18
Loading ...
Loading ...
Loading ...