Loading ...
Loading ...
Loading ...
4
REMOTE CONNECTION
This amplier is designed to accept a 12 AWG – 16 AWG wire input on the terminal
block for speaker outputs 1 and 2. (Diagram A). The Remote Turn-on is how the
amplier knows when to turn on and off. This is typically connected to the remote
output wire on an aftermarket radio. When connecting this amplier to a factory
radio, you will need to nd a +12 volt accessory wire that switches on and off with
the key.
AMPLIFIER SIGNAL INPUTS
Connect the RCA outputs from the source unit into the inputs of the amplier. The
HTX Series has 1 pair of inputs for each pair of channels (6 channel shown below,
other models will vary).
Wet Sounds HTX Series Owner’s Manual
There are 2 different input selection switches. The rst is to designate 2 or 4
channel input. You can select 2 channel input when only using 1 set of RCA inputs
to allow all 4 channels to have output (CH 1,2,3, & 4). The next is to turn on or
off the inputs for channels 5 & 6.(See below) Ch 5 & 6 can be carried over from
inputs 1 & 2 when in 2CH mode, or a separate set of RCA cables can be used in
6CH mode.
**note if you only use the amplier in 2 channel input mode you will not have fading
capabilities between front and rear outputs.**
Loading ...
Loading ...
Loading ...