Wet Sounds HTX-2 User Manual

Loading ...

TROUBLESHOOTING

1. Check your fuse and replace if necessary.

2. Conrm your Ground wire has a good connection.

3. Make sure your remote wire and power wire has +12 Volts.

4. Make sure your battery has 12 volts.

5. Conrm that the amplier LED color is blue. If the light ashing is red than the

amplier is in protection mode. If the light is red check the following items below:

A. See what sequence is ashing by referencing the chart below

B. Conrm that a/the speaker is not blown.

C. Conrm that there are no loose wires that could be grounding out the

amplier.

D. Check that the amplier has sufcient air circulation where it is

located. Insufcient air ow and overdriving the audio system could

result in the amplier going into protection to preserve the amplier.

If you are experiencing problems with your amplier after

installation follow these procedures to try and remedy the

problem.

Wet Sounds HTX Series Owner’s Manual

or HTX 4, 6 ampliﬁers, a short will only shut down the channels which are in fault. The other channels will

contiunue to play

. After a fault connec

tion is cleared, the error code will continue to ﬂash, while the logo is

still illuminated blue. Please contact Tech Support for additional assistance, questions, etc.

Wet Sounds HTX Fault Codes

Circuit Board

Loading ...

Wet Sounds HTX-2 HTX2 Class D Subwoofer Amplifier HTX2