Loading ...
Loading ...
Loading ...
.E
_E
Howto Checkthe Fuel Filter
NOTE:Beforeyou replacethe fuel filter or the fuel line, the
fuel tank must be empty.
If the fuel filter is dirty, the engine will run rough and have
less performance. Removethe old filter (Figure31). Replace
the old filter with a new filter. Usean original equipment
part. Seean authorizedservice dealerin your area.
Figure31: Fuelfilter
A - Fuelline
B- Clips
C - Fuelfilter (example only)
ChecktheTires
Checkthe air pressure in the tires. Tires with too much air
pressure will causethe unit to ride rough. Also, thewrong
air pressure will keepthe mower deck from cutting level.
Recommendedair pressure is 14 PSI(1 BAR)for both front
and reartires.
MowerDeckMaintenance
Howto Removethe Mower Deck(42" Models)
1. Move the blade rotationcontrolto the DISENGAGE
position.
2. If equipped, removethe gaugewheels.
3. Openthe deck levelposition cover, and move the deck
lift lever to the leveladjustment position (Figure32).
,_ WARNING:The decklift lever isspringloaded.Makesure the decklift lever is lockedin the LEVEL
ADJUSTMENTposition.
4. Removethe hair pins and the washersfrom the
adjusterarms (Figure33). See illustrations "C" and
_D _"
5. Removethe hair pins and washers from the
suspensionlinks. Seeillustrations "A" and "B".
Figure32: Deckrift lever
A - Decklevelposition cover (partially hidden)
B - Deckleveladjustment position
6. Removethe end of the bladeengage cablehousing
from the bladeengagecable bracket,then unhook the
cablespring from the mower deck idler. See
illustration "E".
7. Disconnectthe fronthangerfrom the axlesupport. See
illustration "F".
8. Removethe mowerdrive belt from thestackpulley.
9. Pull the mower deck awayfrom the right side of the
unit.
10. To operatewithout the mower deck, move the deck lift
leverto the TOPposition.
Howto Install the Mower Deck(42" Models)
1. Push the mower deck under the right side of the unit.
2. Put the mower drivebelt around the stack pulley.
Make surethe "V" side of the mower drivebelt is
against the stackpulley.Also, makesure the mower
drivebelt isnot twisted.
3. Attachthe fronthangerto the axlesupport with the
hangerrod. Fastenwith the fasteners as shown. See
illustration "F".
4. Make sure the mowerdrive belt is betweenthe stack
pulley and the two belt guides. Seeillustration "G".
5. Attach thesuspensionlinks to the lifter assembly.
Fastenwith thewashers and hair pins. Seeillustrations
"A" and "B".
6. Attach the right and the left adjusterarmsto the
suspension brackets.Fastenwith the washers and hair
pins. Seeillustrations "C" and "D".
7. Hook the blade engagecablespring onto the deck idler,
and firmly press the end of the bladeengagecable
housing into the blade engagecablebracket. See
illustration "E".
8. Move the blade rotationcontrolto the ENGAGE
position. Make surethe mowerdrive belt is inside all
the belt guides.
9. Make sure the mower deck is level.Seethe instructions
on "How To LevelThe Mower Deck".
28
English
www.snapper.com
Loading ...
Loading ...
Loading ...