Loading ...
Loading ...
Loading ...
DIAGNOSTIC CODES
If the setup mode is entered and one of the following has occurred, the appropriate diagnostic
code will be in the display.
d5
d9
d13
d16
F20
F22
Blocked coin 1 or coin drop control circuit failure (coin recognition and price
display disabled while blockage persists). PR Models Only: Setup mode J. should
be set to _d (or Ed if in Enhanced Debit) to eliminate coin related diagnostic
codes.
Voltage detected below 90 vac for 8 seconds.
Blocked coin 2 or coin drop control circuit failure
(coin recognition and price display disabled while blockage persists).
Not receiving communications from installed debit card reader in
Generation 2 debit mode.
Slow Fill. The washer will not detect water input for 4 min. Pressure switch failure
or no water inlet. This code is reported as d8 on d7
The door is not able to lock. Door lock error or someone trying to start the washer,
by pressing the door switch with the finger. This code is reported as dl 7 on Accu
Trac.
(For different code consult service personnel)
WASHER HELP MODE
This mode is entered by pressing the PERMANENT PRESS keypad while in special pricing
option mode 2.XX (or while dAS displays if operating with Maytag Data Acquisition setup).
In help mode, other display symbols and elements are mapped to reflect the state of various
inputs and outputs as follows:
Wash
Circle above digit
DOOR I.OCKED
COI.I)
HOT
OR
AVAII.ABI.E
Water sensed at wash level
I.ow voltage present (below about 90 vac)
Door closed
I)oor sensed locked
Cold water relay on
Hot water relay on
Door unlock
I)rain pump ON
Cleaning the Door Seal/Bellow
Open the washer door and remove any clothing or items from the washer.
Inspect the black colored seal/bellow between the door opening and the basket for
stained areas. Pull back the seal/bellow to inspect all areas under the seal/bellow and to
check for foreign objects.
3. If stained areas are found, wipe down these areas of the seal/bellow, using the procedure
that follows.
a) Mix a dilute solution, using 3/4 cup (177 ml.) of liquid chlorine bleach, and 1 gal.
(3.8 I.) of warm tap water.
b) Wipe the seal/bellow area with the dilute solution, using a damp cloth.
c) I.et stand 5 minutes.
d) Wipe clown area thoroughly with a dry cloth and let the washer interior air dry with
door open.
IMPORTANT:
• Wear rubber gloves when cleaning for prolonged periods.
• Refer to the bleach manufacturer's instructions for proper use.
Washer Maintenance Procedure
This washer has a special cycle that uses higher water volumes in combination with
AFFRESH rM washer cleaner or liquid chlorine bleach to thoroughly clean the inside of the
washer.
1.
2.
S
A NOTES:
A. Seal/Bellow
• Read these instructions completely before beginning the cleaning process.
If necessary, the cleaning cycle may be interrupted by pressing the I)EI_ICATES & KN ITS
button twice. However; this will not immediately stop the cycle. The machine will
continue with several rinse and drain steps to ensure that all remaining bleach is rinsed
from the washer.
Loading ...
Loading ...
Loading ...