Loading ...
Loading ...
Loading ...
Pull the saw blade through the
workpiece to the distance shown below.
12. Support and hold the workpiece down
and against the fence firmly with your left
hand.
13o Pull blade through fence and workpiece
,just enough to complete the cut. Fig 1t2
14o Return saw to its rearmost position and
continue to hold the saw handle°
15. Turn saw off.
16, Wait for the blade to stop turning,
17. Remove yellow key form red switch,
Fig, 112 Distance Needed to Complete Crosscut
10. Insert yellow key into red switch.
11. Turn saw on,
iX
WARNING: Saw blade can be
pulled into or over fingers or
hand. Fingers or hand can be cut off.
Keep hand holding the workpiece at
least 8 inches to the left of, and out of
the path of_the saw blade. Keep hand in
view at all times.
Repetitive Crosscuts
To make repetitive crosscuts:
1. Use two pieces of 1 inch by 2 by 2 inch
lumber.
2, Use a C clamp to clamp one piece on each
side of the lower right edge of the radial arm.
3. Clamp pieces of lumber at the distance
necessary to complete the crosscut,
Fig. 113 Hand Placement for Crosscuts
53
Fig, 114
Loading ...
Loading ...
Loading ...