Loading ...
Loading ...
Loading ...
22° Lock the rip lock, put the spacer, fence
and rear table back in place, lock the table
clamp, and go to the next section.
If there is a gap between the square and the
the blade after any rotation (Figure 73), go
to step 6.
Squaring Blade to Table
for Crosscutting
These steps are necessary so that your blade
will be perpendicular to the table and cuts
will be accurate_ If this is not done correctly,
your cuts will have a slight bevel angle.
1. Put the radial arm in the 0 ° miter position
with the blade over the front table_
2o Lock the table clamps and rip lock.
3. Place the long edge of the framing square
on the table and the short edge against the
blade. Make sure that the square is against
the blade surface and not the set of a tooth.
(Figure 72)
Right
t i Square j_
Table
Wrong _ j_____ Wrong I-]"
Square[ _ Square [_
Table Table
Fig. 73
6. Unlock the bevel lock, but do not move the
motor.
7. Loosen the four screws behind the yoke
using a 1/8 inch hex-L wrench. (Figme 74)
Framing
Square
FI#. 72
4. Turn the blade with your hand several
times and check to see if the square is flush
with the blade.
5. If the square is flush with the blade after
each rotation, no change is needed. (Figure
73) Go to the next section, or
1 __Setscrews
f- ® /I
Fig. 74
8. Hold the square in place and move the
motor slowly until the square is flush with the
blade.
30
Loading ...
Loading ...
Loading ...